Is powers owned by Dewalt?
Once construction begins, DEWALT has been the trusted brand of choice for Contractors using professional power tools. In 2012, Powers Anchors and Fasteners became part of the DEWALT family, part of the key mission to own the entire project, from the design phase and through the construction phase.
How deep should anchor bolts be in concrete?
Diameter of hole should be 3 to 4 times the diameter of the fixture being placed and the depth of the hole must be 8 to 12 times the fixtures diameter. The area receiving the material should never be less than 2” deep and 2” wide.
How deep should anchor bolts be in concrete slab?
1/2″
Rule: When drilling a hole into concrete, brick or block base material- the hole must be drilled 1/2″ deeper than the concrete anchor will penetrate. Explanation: The extra depth of the hole will ensure that the anchor does not bottom out and will allow space for any dust that may be created in the drilling process.
What is the difference between wedge and expansion anchors?
The wedge anchor can only be used in solid concrete. Wedge anchors are designed not to be used in other masonry materials such as brick or hollow block. The expansion clip on the wedge anchor is placed on the anchor body in a manner and location that makes the expansion tolerance location critical.
What is a drop in anchor?
Drop-In anchors are female concrete anchors designed for anchoring into concrete. Drop the anchor into the pre-drilled hole in the concrete. Using a setting tool expands the anchor within the hole in the concrete. The outside diameter of the anchor is equal to the hole diameter required to be drilled in the concrete.
Did DeWalt buy Powers Fasteners?
Late last week DeWalt’s parent company, Stanley Black & Decker, purchased Powers Fasteners. Why should this matter to you?
Are Stanley and DeWalt the same?
Here are two things you probably don’t know: One, a whole bunch of the top power tool brands — including DeWalt, Black & Decker, Craftsman, Porter-Cable and more — are all owned by the same company, Stanley Black & Decker.
How deep should concrete anchors go?
1/4 in.
Make Sure to Drill the Hole Deep Enough Holes for concrete screws should be at least 1/4 in. deeper than the screw will penetrate to allow a little extra space for dust accumulation from the drilling process.
What are the different types of anchor fasteners?
Anchor Fasteners by American Fastener Hammer Drive Anchors Lag Screw Shields Toggle Wings Plastic Anchors Wedge anchors Flat Head Sleeve Anchors Acorn Nut Sleeve Anchors Hex Nut Sleeve Anchors
What are the best screws for concrete?
There are two kinds of screw heads for work with concrete — hex head or flat head Phillips. Hex screws are easier to drive in, but they don’t look as nice because the caps are raised and they can’t be flush to the surface; so your choice depends on the location of the screw.
What is a J bolt for concrete?
J-bolts are steel bolts of varying lengths and diameters, with a hooked bottom and threading on top. The hook is designed to hook onto the rebar embedded in the concrete. In residential construction, 1/2-inch diameter J-bolts are typically utilized to anchor walls to concrete. The J-bolt prevents the wall from rising or sliding off the foundation.
What are anchor studs?
Stud anchors are made from a steel rod, with one end threaded and the other end necked down with a clip that is permanently attached. Stud anchors are packaged with one nut and one washer. Stud anchors are simple to use, have excellent holding values and come in a wide variety of diameters and lengths.