Can you disable TPMS Silverado?
Although you cannot disable the TPMS in a General Motors (GM) vehicle, you can reset the system if you recently checked your tires and inflated them properly. If you do not adequately inflate the tire, however, the TPMS trouble light will remain on.
How do you reset the tire pressure sensor on a Chevy Silverado?
Turn your vehicle’s key to the “On” position without starting the vehicle. Push the TPMS reset button until the tire pressure light flashes three times, then let go. Start the car and wait for about 20 minutes for the tire pressure sensor to refresh.
How do you reprogram a Chevy tire pressure sensor?
Manual relearn procedure, Base Level DIC, 2015-2020:
- Confirm TPMS sensors are properly installed.
- Adjust tire pressures to placard value.
- Apply parking brake.
- Turn vehicle to ON/RUN.
- Push the trip odometer reset stem until Tire Pressure is displayed.
- Push and hold trip reset stem to begin the sensor matching process.
How do you reset the tire pressure monitoring system on a Chevy Silverado?
With the engine off, turn the ignition key to the RUN position. This will put the vehicle into reset mode and alert you with two clicks of the horn before the tire pressure monitor service light begins to flash. To reset the truck, turn the headlight switch from ON to OFF four times within three to four seconds.
How do you turn off the TPMS light on a 2010 Chevy Silverado?
Switch the ignition key to the “On,” or second, location on the ignition but don’t crank the engine. Press and hold the reset button on the instrument panel before blinking begins with the TPMS light and then exits. You should also make sure the tires are at the recommended PSI or else the light will illuminate again.
Is it illegal to disable TPMS?
Q: Some of the older cars we see with a Tire Pressure Monitoring System (TPMS) are experiencing problems with sensors and other components. Sometimes, owners ask us to disable the system to save money. The bottom line: It’s illegal for you to disable the TPMS, either at the request of a customer or on your own.
How do you turn off the sensor light on a tire?
Turn the car key to “on” but don’t start the vehicle. Press and hold the TPMS reset button until the tire pressure light blinks three times. Release the button and start the car. The light should go off within 20 minutes.