Does Traktor work with Android?
Traktor Pro is not available for Android Tablet but there are a few alternatives with similar functionality. The best Android Tablet alternative is Djay.
How do I set up audio on Traktor?
Setting up your Audio Interface in TRAKTOR DJ
- Connect your compatible NI audio interface to your iOS device.
- Launch TRAKTOR DJ.
- Press the gearwheel symbol to access the TRAKTOR DJ Preferences.
- Select the Audio Setup menu and check the output channels to be used as Master Outputs and Monitor Outputs.
Does Traktor support AAC?
AAC (On Windows, AAC playback requires Apple Quicktime to be installed on the computer.) Note for Windows 7 / 8 users: TRAKTOR versions 2.7. 0 or higher are unable to play back Apple Lossless (ALAC) files.
How do I set up Traktor Pro 2?
Run the Setup Wizard by clicking on the Setup Wizard button in the lower left corner of the TRAKTOR Preferences. In the DECK LAYOUT SELECTION, choose 2 Track Decks (Scratch). When the Setup Wizard is finished, open the TRAKTOR Preferences and go to Audio Setup.
Can I use a controller with Traktor DJ 2?
Will TRAKTOR DJ 2 work with my controller? The TRAKTOR KONTROL S2 MK2, TRAKTOR KONTROL S4 MK2, TRAKTOR KONTROL S2 MK3, TRAKTOR KONTROL S3, TRAKTOR KONTROL Z1, TRAKTOR AUDIO 2 MK2, and any other audio interface will be supported. We plan on supporting more controllers in the future.
What’s the best latency setting for Traktor?
512 MS
Below the Audio device menu, you can choose your Sample Rate and Latency settings. The recommended setting for using Traktor on most MacBook Pro is 44100 Hz Sample rate and 512 MS Latency. This is because this is the standard sample rate used by most CDs.
Can CDJ play AAC?
The CDJ-900 supports AAC files in the formats shown below. Compatible formats MPEG-4 AAC LC Sampling frequencies of 16 kHz, 22.05 kHz, 24 kHz, 32 kHz, 44.1 kHz and 48 kHz, and bit rates of 16 kpbs – 320 kbps are supported. The CDJ-900 supports AIFF files in the formats shown below.
Can you use timecode vinyl with Traktor Pro 2?
You cannot use timecode with Traktor Pro 2. It has to be Traktor SCRATCH Pro 2. You must buy TSP2. You can then sell the serial number for your existing Traktor Pro 2 software.
Where to find soundcard settings in Traktor Pro?
The Audio Setup window is where you choose and configure your soundcard settings. In the Audio Device menu, you choose what soundcard you’re using (i.e. Traktor Audio 10, Traktor Kontrol S4, etc.) If you don’t have a soundcard connected, you can always use your computers built in soundcard.
What should my audio preferences be in Traktor?
When getting setup to play live in Traktor, there are three very important sections of the preferences to check: The Audio Setup window, Output Routing, and Input Routing. Most audio problems and troubleshooting is usually done here.
Where does the signal go in Traktor Scratch Pro 2?
The signal from Deck A will go to the Output Channel A (3-4) on the audio interface, Deck B will go to Output Channel B (5-6) and so on. If you are not using an external mixer, connect one Output Channel of your audio interface to the line input of your speaker system.
How to set Traktor to External Mixing mode?
If you are using an external mixer, connect the outputs of your audio interface to the line inputs (not phono!) of your external mixer. Go to the Output Routing in the TRAKTOR Preferences. Set the Mixing Mode to External. The outputs will automatically be set in the correct order, which looks like this: